FM-04: 锯片速度或切割力低于正常

刀片转动，但速度或切割力低于正常，且木材支撑正确。

• Battery charge or output is too low for the load
• Blade is dull, dirty, damaged, or unsuitable
• Blade rotation, size, arbor, or speed rating is incorrect
• Cut depth is excessive or feed pressure is too high
• Motor, bearing, or electronic drive fault

1. A clean supported test cut proceeds smoothly at normal blade speed.

1. Release the trigger, remove the battery, and inspect the installed blade.
2. Fit a clean sharp blade of the correct size, arbor, rotation, tooth count, and speed rating.
3. Set depth so about one-half tooth projects below the work and support the material near the cut.
4. - Test with a charged known-good pack and steady feed - if output stays low, seek service.

这是完整维修手册中所含故障排除指南的预览。

• 圆锯片
• 主轴、齿轮箱和刀片
• Motor、齿轮箱或主轴

• 锯片速度或切割力低于正常

  刀片转动，但速度或切割力低于正常，且木材支撑正确。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。