FM-01: 锯子无法启动或无任何反应

- 按下锁止按钮和扳机时，motor 或锯片无任何动作 - 工作灯可能保持熄灭。

• Battery pack is discharged, too hot or cold, or faulty
• Pack is not fully seated or its contacts are obstructed
• Trigger lock-off button is not fully released or is damaged
• Trigger movement is blocked or damaged
• Internal switch, controller, or motor fault

1. The saw starts normally with a latched known-good pack.

1. Release the trigger, remove the battery, and let all blade motion stop.
2. Inspect the battery rails, contacts, lock-off, and trigger for damage or loose dry debris.
3. Install a charged known-good compatible pack until it latches, then press lock-off and pull the trigger.
4. - Test at no load - if motor, blade, and worklight stay dead, keep the saw out of service.

这是完整维修手册中所含故障排除指南的预览。

• 兼容FLEXVOLT battery
• 触发器和电子module
• 完整锯
• 触发锁止和触发器
• FLEXVOLT battery 接口
• 电子 module 和 motor

• 锯子无法启动或无任何反应

  - 按下锁止按钮和扳机时，motor 或锯片无任何动作 - 工作灯可能保持熄灭。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。