症状
浏览已记录的症状，并从搜索结果跳转到匹配的维修指南。
The tool works until the pack, handle, or tool is bumped or shifted, then loses power.
0 份相关手册
查找指南 →
At room temperature, the battery is fully seated in a powered known-good compatible charger, yet the charger never enters its normal charging state.
0 份相关手册
查找指南 →
The collar will not align or hold, or screwdriving clutch cut-off is absent or premature.
0 份相关手册
查找指南 →
The stable pack is cracked, crushed, punctured, burned, deformed, swollen, corroded, or has damaged contacts, barriers, insertion stem, or release tabs.
0 份相关手册
查找指南 →
A known-good compatible charger begins its normal charging cycle, but the cycle repeatedly stops, restarts, faults, or continues abnormally without reaching completion.
0 份相关手册
查找指南 →
The motor can be heard, but the chain remains stationary or only twitches while the trigger is held.
0 份相关手册
查找指南 →
The included compatible charger shows no status light and will not begin charging a sound pack.
0 份相关手册
查找指南 →
鋸完成切割，但0度切割不方正，斜切角度與刻度不符，或切口偏離預期角度。
0 份相关手册
查找指南 →
A compatible charger continues to report its temperature-delay state after the battery has stabilized at room temperature and the charger works normally with another compatible battery.
0 份相关手册
查找指南 →
The charger shows charging or hot/cold delay, but the pack never reaches its normal charged indication.
0 份相关手册
查找指南 →
Starts, then stops while cool
0 份相关手册
查找指南 →
Chuck clicks while tightening
0 份相关手册
查找指南 →
motor同鐵砧正常運行，但LED冇正確照亮即時工作區。
0 份相关手册
查找指南 →
Direction button centered
0 份相关手册
查找指南 →
扳機回彈同motor停止，但LED保持亮起超過大約20秒。
0 份相关手册
查找指南 →
A proven compatible charger gives its normal full-charge indication, yet the removed battery shows little or no charge and can run a known-good low-load tool only briefly or not at all.
0 份相关手册
查找指南 →
The pack is fully or partly engaged but cannot be removed by operating the normal release and pulling straight.
0 份相关手册
查找指南 →
Trigger binds, fails to return, changes speed erratically, or does not stop the drive.
0 份相关手册
查找指南 →
方向選擇器移動並保持正常卡位，但夾頭唔喺一個方向運轉或反方向旋轉。
0 份相关手册
查找指南 →
The battery will not slide fully into the tool, click into place, stay latched, or release normally.
0 份相关手册
查找指南 →