搜索维修指南
在知识库中查找维修指南、手册、症状和错误代码。
With the bit removed, the driver makes continuous abnormal grinding, knocking, or scraping.
The motor can be heard, but the front output remains still in both directions with the bit removed.
The trigger returns normally and power drops, but the anvil repeatedly coasts instead of stopping promptly.
墊轉動時出現異常驅動接觸聲
With no fastener load, the bare or correctly fitted output sounds harsh, binds, knocks, or shakes abnormally.
The direction lever will not reach forward, reverse, or center lock, or the selected position does not hold.
THE BATTERY WILL NOT SEAT, LATCH, RELEASE, OR STAY SECURE
A straight bit traces a visible circle at no load instead of rotating on a stable centerline.
WORKLIGHT COMES ON, BUT THE MOTOR WILL NOT START
A straight bit or socket visibly orbits, shakes, or runs off-center during a brief no-load test.
After trigger release, the bit or square drive coasts noticeably longer than normal before stopping.
Trigger binds, fails to return, changes speed erratically, or does not stop the drive.
Tool rotates, but a seated fastener gets little torque or no normal impact pulse.
A correct-looking bit will not enter fully or can be pulled out after the collar is released.
Prosty bit pozostaje zaciskany, ale obraca się poza środek lub korpus uchwytu ma widoczne luzy.
Chuck clicks while tightening
battery唔會完全滑入手柄、鎖定、保持或正常釋放。
The cool tool starts, then stops during a brief no-load test or light fastening task before heat builds.
Smoke, flame, severe arcing, liquid, battery damage, melted contacts, exposed parts, or cracked structure.
BATTERY WILL NOT CHARGE
FM-21: FM-21 INTERNAL GRINDING, KNOCKING, OR SCRAPING AT NO LOAD
FM-19: FM-19 MOTOR RUNS, BUT THE CHUCK AND ANVIL DO NOT ROTATE
FM-19: 墊轉動時出現異常驅動接觸聲
FM-15: 墊喺墊組裝維修後卡住
FM-16: FM-16 BIT WILL NOT RELEASE, OR A SHORT OR BROKEN BIT IS TRAPPED
FM-18: FM-18 A KNOWN-STRAIGHT BIT SHOWS VISIBLE WOBBLE OR RUNOUT
fm-2-1-4: FM-22 BIT BINDS, TOOL STALLS, TWISTS, OR STOPS IN THE WORK
FM-05: FM-05 SPEED WILL NOT VARY, SURGES, OR CUTS ERRATICALLY
FM-17: FM-17 THE BIT SLIPS OR PULLS OUT UNDER LOAD
FM-12: FM-12 ACCESSORY CAMS OUT, BINDS, OR TWISTS THE TOOL
FM-11: FM-11 刹车无法快速停止输出
FM-11: FM-11 正確設置下速度或扭力低
FM-14: FM-14 電鑽空載時磨損或震動
FM-12: FM-12 鑽頭卡住、卡死或扭轉電鑽
FM-27: FM-27 工具或電池包過熱，或者熱量熄火重複發生
FM-02: 电池组无法安装、锁定或释放
FM-04: FM-04 UNEALTĂ PORNEȘTE, APOI SE OPREȘTE CÂND ESTE RECE
FM-04: FM-04 鑽頭冷卻時斷電
FM-16: FM-16 即時BATTERY、充電器或者工具危險
FM-03: FM-03 BATTERY WILL NOT BEGIN OR COMPLETE CHARGING