搜索维修指南
在知识库中查找维修指南、手册、症状和错误代码。
Motor sound is present, but the anvil and installed bit remain stationary.
The bit rotates, but a real fastening load never produces the normal impact sound or pulses.
The bit inserts, but the collar does not return or a firm tug pulls the bit out.
已裝入充電電池包，但扳機無工作燈、motor聲音或鐵砧動作。
The accessory or fastener stops in the work and the tool stalls, twists, or cannot be withdrawn normally.
The charger shows charging or hot/cold delay, but the pack never reaches its normal charged indication.
The housing, handle, rails, nose, vents, lens, or accessory mount is cracked or loose.
The accessory slips from the fastener, damages it, breaks it, or drives it beyond the intended seat.
The quick-release collar binds, will not move fully forward, or stays forward after release.
The tool or pack becomes unusually hot, or operation stops only after heat builds.
扳機回彈同motor停止，但LED保持亮起超過大約20秒。
The release button moves poorly or the pack remains trapped on the tool rails.
Tombol maju/mundur tidak masuk, kunci tengah gagal, atau alat berjalan ke arah yang salah.
The motor can be heard, but the front output remains still in both directions with the bit removed.
WORKLIGHT COMES ON, BUT THE MOTOR WILL NOT START
The trigger returns normally and power drops, but the anvil repeatedly coasts instead of stopping promptly.
工具完全死機 - 無LED或MOTOR
Pemicu menyalakan area kerja, tetapi motor tetap diam dan landasan tidak bergerak.
Pemicu macet, gagal kembali, atau motor tetap menyala setelah dilepaskan.
Bright repeated arcing or sharp crackling is visible at the rear vents while the tool runs.
FM-19: MOTOR運行，但鐵砧同批頭唔轉動
FM-02: 工作燈亮，但 MOTOR 唔會啟動
FM-18: 已知直嘅批頭有明顯擺動或偏擺
FM-12: 工作燈死、暗或間歇，當MOTOR運行時
FM-14: 夾頭套圈唔能拉前或回位
FM-08: BATTERY唔能從工具釋放
FM-21: 內部驅動磨損、敲擊、刮擦或運行不順
FM-20: 鐵砧旋轉，但負載下衝擊從未開始
FM-22: 驅動輸出低，儘管旋轉同衝擊穩定
FM-27: FM-27 工具或電池包過熱，或者熱量熄火重複發生
FM-23: 緊固件打滑、剝落、斷裂或過度擰緊
FM-16: 批頭唔釋放，或短批頭或斷批頭被困
FM-26: 充滿電嘅電池包運行時間異常短
FM-01: FM-01 工具完全死機 - 無LED或MOTOR
FM-28: 後部通風口出現嚴重BRUSH電弧或爆裂聲
FM-17: 批頭唔鎖定、拉出或套圈唔就位
FM-13: 工作燈持續亮超過正常餘光時間
FM-03: 扳機卡住，唔會回彈，或者MOTOR持續運行
FM-04: 扳機釋放後夾頭旋轉時間過長
FM-25: FM-25 工具負載下關機，無機械卡住
正確的衝擊等級鑽頭或套筒
兩個聲音衝擊等級1/4吋六角附件
精確批准的可選掛鉤及附帶的screw
乾布
V20 充電器
兩個已知直線衝擊等級1/4吋六角鑽頭
V20 battery 電池包
起子頭或者起子頭座
機載鑽頭架
可變速扳機
模式或者扭力領圈
充電器同指示燈
相容嘅 battery
En rak rundskaftad borrbits
arbetsstycke
En godkänd battery laddare
Ett kompatibelt 12V MAX* battery paket
Cool known-good Bosch 18V battery
Correct impact bit
Halbzoll-Schlag-Steckschlüssel