FM-23: 切割深度唔能設定、鎖定、保持或者達到正常範圍

鞋板唔能滑到想要嘅鋸片露出深度，深度桿扣唔實，切割時深度改變，或者用正確鋸片時明顯達唔到最大深度。

• Sawdust is packed at the depth guide, lever, or shoe slide
• Depth lever is loose, stripped, cracked, or incorrectly adjusted
• Shoe, depth guide, or guard is bent or obstructed

1. The depth moves freely, locks without slip, repeats the chosen exposure, and allows the specified normal range with the correct blade.

1. Remove the battery, loosen the depth lever, and clear exposed dry sawdust from the depth guide, lever, and shoe movement path.
2. Confirm the correct blade is centered and clamped, and inspect the shoe, guide, lever, and lower guard for bend, crack, interference, or missing hardware.
3. Move the shoe to expose about one-half tooth below the intended material and retighten the lever in the official direction before cutting.
4. - Check that the setting does not move by hand and that normal travel includes up to 2-9/16 inches at 90 degrees with the correct blade - if not, use authoriz

这是完整维修手册中所含故障排除指南的预览。

• 深度桿、導向同刻度
• 鞋同結構樞軸
• 下鋸片護罩、收回桿、樞軸同彈簧
• 7-1/4吋木材切割鋸片

• 切割深度唔能設定、鎖定、保持或者達到正常範圍

  鞋板唔能滑到想要嘅鋸片露出深度，深度桿扣唔實，切割時深度改變，或者用正確鋸片時明顯達唔到最大深度。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。