FM-22: 斜角唔能設定、鎖定、保持或者讀取正確

鞋板唔能喺預期範圍傾斜，斜角桿扣唔實，切割時角度滑動，或者指針/刻度唔能提供可重複嘅角度。

• Sawdust is packed at the pivot, quadrant, pointer, or lever
• Lever is loose, stripped, cracked, or incorrectly positioned
• Shoe, pivot, quadrant, or pointer is bent or worn
• Zero calibration or angle reading is being confused with a general locking failure

1. The shoe sets within its range, locks firmly without movement, and produces a repeatable verified bevel angle.

1. Remove the battery and set the saw on a stable surface before touching the bevel lever or shoe.
2. Clean the exposed pivot, quadrant, pointer, and lever dry, then inspect for cracks, bend, missing hardware, or a lever that cannot clamp.
3. Loosen the lever counterclockwise, tilt the shoe to the desired marked angle within 0-57 degrees, and retighten the lever clockwise firmly.
4. - Check for movement by hand and confirm the angle with a gauge or a controlled scrap cut - use FM-21 only for a zero-degree calibration error.
5. If the shoe cannot move, lock, hold, or read repeatably, keep the saw out of service for authorized lever, pivot, quadrant, pointer, and shoe repair.

这是完整维修手册中所含故障排除指南的预览。

• 斜角桿、象限、指針同零點校準
• 鞋同結構樞軸

• 斜角唔能設定、鎖定、保持或者讀取正確

  鞋板唔能喺預期範圍傾斜，斜角桿扣唔實，切割時角度滑動，或者指針/刻度唔能提供可重複嘅角度。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。