FM-18: 鋸片卡住、夾緊、擠壓或者鋸機喺切割時反彈

鋸片被切縫卡住或者減速，鋸機向操作員抬起或者反推，或者嘗試喺鋸齒卡住材料時重新啟動。

• Workpiece is supported so the kerf closes and pinches the blade
• Blade is dull, dirty, bent, wrong, too deep, or twisted off the line
• Saw was started against the work or forced, turned, or backed in the cut
• Wet, knotty, treated, or unstable wood is loading the blade

1. The saw enters at full speed and completes a supported straight scrap cut without kerf closure, stall, twist, lift, or kickback.

1. Release the trigger immediately, hold the saw firmly until the blade stops and guard closes, then remove the battery before freeing the blade.
2. Support the work close to the cut so the cutoff cannot sag into the kerf, and remove nails, wire, unstable pieces, and binding forces.
3. - Inspect and replace a dull, dirty, bent, damaged, or wrong blade - set depth to about one-half tooth below the material and secure both adjustment levers.
4. Reposition the shoe flat and straight, bring the blade to full speed before contact, and feed at a rate that lets the blade cut without laboring or turning
5. - Make one supported scrap cut - if binding occurs with correct support, blade, depth, alignment, and feed, stop and route guard, shoe, spindle, and drive ali

这是完整维修手册中所含故障排除指南的预览。

• 斜角桿、象限、指針同零點校準
• 鞋同結構樞軸
• 木材切割圓鋸片
• 主手柄、輔助手柄同保護結構
• 深度桿、導向同刻度
• 齒輪箱、齒輪、軸承或主軸
• 下鋸片護罩、收回桿、樞軸同彈簧
• 齒輪箱、齒輪、軸承同主軸
• 7-1/4吋木材切割鋸片

• 鋸片卡住、夾緊、擠壓或者鋸機喺切割時反彈

  鋸片被切縫卡住或者減速，鋸機向操作員抬起或者反推，或者嘗試喺鋸齒卡住材料時重新啟動。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。