FM-13: 鋸機或者齒輪箱異常熱或者有熱味但無煙霧或火花

外殼、齒輪箱、battery 接口或者 motor 區域加熱異常快或者有熱嘅機械/電氣氣味，但無可見煙霧、火花、熔化或者液體。

• Vents are blocked by sawdust or the saw is being forced
• Dull, dirty, wrong, or deeply set blade is overloading the motor
• Blade, guard, bearing, or gear drive is dragging
• Battery, motor, electronic module, bearing, or gearcase is failing

1. After correction, one controlled light cut produces normal temperature rise only, with free blade/guard movement and no hot odor.

1. Release the trigger, keep control until the blade stops and guard closes, remove the battery, and let the saw cool in a dry noncombustible area.
2. - Inspect for smoke, sparks, melting, liquid, battery damage, or worsening odor - route those conditions immediately to FM-06 or FM-14.
3. Clean the vents with dry air, correct blade depth and work support, and replace any dull, dirty, damaged, or wrong blade.
4. With the battery removed, hand-turn the blade and check the lower guard for free motion without scrape or drag.
5. - Use a known-good pack for one light supported scrap cut - if rapid heat or hot odor returns, stop and request authorized motor, electronic, bearing, and gea

这是完整维修手册中所含故障排除指南的预览。

• 深度桿、導向同刻度
• 冷卻通風口同外殼
• 齒輪箱、齒輪、軸承同主軸
• 7-1/4吋木材切割鋸片
• 電子module或無刷motor
• 電子module、無刷motor同電動制動

• 鋸機或者齒輪箱異常熱或者有熱味但無煙霧或火花

  外殼、齒輪箱、battery 接口或者 motor 區域加熱異常快或者有熱嘅機械/電氣氣味，但無可見煙霧、火花、熔化或者液體。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。