FM-12: 工作燈失效、閃爍或者持續亮過正常延遲時間

motor 正常運作，但集成工作燈唔亮、同穩定嘅battery一齊閃爍，或者亮得比正常扳機後延遲時間耐。

• Worklight lens or opening is packed with sawdust
• Battery or trigger input is intermittent
• LED, light wiring, or electronic timing control has failed
• Normal delay of about 20 seconds is being mistaken for a fault

1. The worklight illuminates steadily with trigger operation and turns off automatically after its normal delay.

1. - Confirm the motor operates normally and time the light only after the trigger is fully released - a delay of about 20 seconds is normal.
2. Remove the battery and clean the light opening and surrounding external area with a dry brush or clean dry air.
3. Install a known-good fully charged compatible pack and repeat a brief no-load trigger-and-release check.
4. If the motor remains normal but the light still fails, flickers, or remains on abnormally, leave the housing closed and request authorized light or control

这是完整维修手册中所含故障排除指南的预览。

• 工作燈或內部線路
• 工作燈同鏡片

• 工作燈失效、閃爍或者持續亮過正常延遲時間

  motor 正常運作，但集成工作燈唔亮、同穩定嘅battery一齊閃爍，或者亮得比正常扳機後延遲時間耐。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。