FM-11: 空載鋸片速度低、波動或者接觸木材前斷斷續續

鋸片未接觸任何材料時，鋸機運行唔均勻，速度反覆變化，或者達唔到正常穩定嘅空載聲音。

• Battery is weak, temperature-protected, loose, or making poor contact
• Blade or lower guard is rubbing because of incorrect assembly or damage
• Vents are blocked and the motor/electronics are overheating
• Trigger, electronic module, motor, bearings, or gear drive is failing

1. The blade accelerates promptly to a steady normal no-load sound and remains free of rub, surging, and intermittent power.

1. Release the trigger, wait for the blade to stop, remove the battery, and do not make a cut while no-load speed is unstable.
2. - Inspect the battery fit, contacts, blade clamp stack, guard clearance, and vents - correct dry debris, visible rub, or assembly error.
3. Hand-turn the blade with the battery removed to check for smooth free rotation without scraping, then install a known-good fully charged compatible pack.
4. Make one brief no-load run with the blade clear and listen for steady acceleration and speed.
5. If surging, intermittent power, or low no-load speed remains, stop use and route the saw for authorized switch, electronic, motor, bearing, and gear-drive

这是完整维修手册中所含故障排除指南的预览。

• 冷卻通風口同外殼
• 7-1/4吋木材切割鋸片
• 齒輪箱、齒輪、軸承同主軸
• Battery導軌、接觸點、鎖扣同釋放
• 扳機鎖定同扳機開關
• 電子module或無刷motor
• 電子module、無刷motor同電動制動

• 空載鋸片速度低、波動或者接觸木材前斷斷續續

  鋸片未接觸任何材料時，鋸機運行唔均勻，速度反覆變化，或者達唔到正常穩定嘅空載聲音。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。