FM-03: Battery 運行時間比之前正常充電後短好多

鋸開始時正常切割，但一個完全顯示滿電嘅電池包完成嘅相似切割數量遠少於之前。

• Battery has lost usable capacity through age or cycle history
• Cold pack, wet or dense lumber, deep cuts, or a dull blade is increasing normal energy use
• Contacts are dirty or the pack was not actually fully charged
• Internal motor or bearing drag is drawing excessive current

1. Under the same controlled cutting setup, the proven pack delivers repeatable useful runtime without abnormal heat or rapid loss of speed.

1. - Remove any pack that is hot, swollen, cracked, wet, leaking, or scorched - otherwise let it reach normal room temperature and charge it fully.
2. Clean the pack and saw interfaces dry, fit a sharp correct blade, and repeat a documented light-cut comparison in similar dry wood.
3. Repeat the same cut count and setup with a known-good fully charged compatible pack.
4. - Replace or service the pack that consistently delivers much less work - if both proven packs drain abnormally fast, keep the saw closed and request authoriz

这是完整维修手册中所含故障排除指南的预览。

• 兼容FLEXVOLT battery
• FLEXVOLT battery 電池組

• Battery 運行時間比之前正常充電後短好多

  鋸開始時正常切割，但一個完全顯示滿電嘅電池包完成嘅相似切割數量遠少於之前。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。