FM-02: 鋸啟動後喺負載下突然熄火

鋸片達到速度，進入木材，然後所有動力旋轉突然停止，而唔係喺切縫中慢下來或卡住。

• Electronic protection responded to overload, temperature, or deep battery discharge
• Battery is weak, undercharged, too hot, too cold, or moving on the rails
• Blade, depth, feed rate, or work support is creating excessive load
• Blocked vents or an internal electronic or motor fault repeats under load

1. The saw completes a controlled supported cut without abrupt powered shutdown, abnormal heat, or battery movement.

1. Release the trigger, hold the shoe still until the blade stops and the lower guard closes, then remove the battery before freeing the saw.
2. Let the tool and pack cool in a dry ventilated place, and inspect for heat damage, liquid, smoke, sparks, or a battery hazard before any retest.
3. Free the blade from the kerf, correct work support and cutting depth, clean the vents dry, and replace a dull, damaged, dirty, or wrong blade.
4. Install a known-good fully charged compatible pack and make one controlled light cut in supported scrap without forcing the saw.
5. If the powered shutdown repeats while the blade remains free and the proven pack, blade, depth, support, and feed are correct, stop use and route the saw f

这是完整维修手册中所含故障排除指南的预览。

• 深度桿、導向同刻度
• 冷卻通風口同外殼
• 7-1/4吋木材切割鋸片
• 電子module、無刷motor同電動制動
• Battery導軌、接觸點、鎖扣同釋放
• 電子module或無刷motor
• FLEXVOLT battery 電池組

• 鋸啟動後喺負載下突然熄火

  鋸片達到速度，進入木材，然後所有動力旋轉突然停止，而唔係喺切縫中慢下來或卡住。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。