FM-10: 深度調節唔能設定、鎖定或者保持

底板唔能設定或夾緊深度，或使用中切割深度改變。

• Depth lever is not fully loosened or tightened
• Sawdust is packed in the shoe slide or pivot
• Depth scale, lever, pivot, or shoe is bent or damaged
• Fastener or clamping surface is worn or loose
• Internal or structural adjustment repair is required

1. The selected depth stays fixed through a supported test cut.

1. Remove the battery, place the saw on a stable surface, and loosen the depth lever.
2. Brush the slide dry and move the shoe through its full range.
3. Set depth so about one-half tooth projects below the workpiece, then tighten the lever firmly.
4. - Push-test and make a scrap cut - if depth moves or the lever will not lock, seek service.

这是完整维修手册中所含故障排除指南的预览。

• 深度桿同底板
• 深度、斜角或鞋組件

• 深度調節唔能設定、鎖定或者保持

  底板唔能設定或夾緊深度，或使用中切割深度改變。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。