FM-03: 鋸開動後，扳機保持按住時會斷電

鋸機啟動後，扳機保持按住時停轉，負載或空載均然。

• Pack protection opened for charge or temperature
• Blade was pinched, bound, or overloaded by the cut
• Pack is loose or the contacts are intermittent under vibration
• Blocked vents or heavy loading caused thermal protection
• Internal control or motor fault

1. The saw runs steadily at no load and through a controlled supported cut.

1. Release the trigger and wait until the blade stops completely.
2. Remove the battery, free the saw from the work, and clear any pinching or blocked vents.
3. Install a charged known-good pack and run the saw briefly at no load.
4. - If no-load cutout repeats, keep the saw out of service - if stable, correct blade, support, and feed.

这是完整维修手册中所含故障排除指南的预览。

• Motor、齒輪箱或主軸
• FLEXVOLT battery 介面
• 電子 module 同 motor
• 兼容FLEXVOLT battery

• 鋸開動後，扳機保持按住時會斷電

  鋸機啟動後，扳機保持按住時停轉，負載或空載均然。

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

公开页面仅显示预览。购买完整手册以下载全部维修步骤、图示和验证流程。