failure mode
FM-17: FM-17 THE BIT SLIPS OR PULLS OUT UNDER LOAD
FM-17 THE BIT SLIPS OR PULLS OUT UNDER LOAD
Tổng quan chẩn đoán
FM-17 THE BIT SLIPS OR PULLS OUT UNDER LOAD
Nguyên nhân gốc có thể
- Bit did not pass a firm tug test
- Shank groove or hex corners are worn
- Wrong-shank or non-impact accessory is fitted
- Detent, ball, spring, or collar is worn
Kiểm tra nhanh
- The bit remains locked through a controlled drive and then releases normally.
Xem trước sửa chữa
1.
Đây là bản xem trước hướng dẫn khắc phục sự cố trong sách hướng dẫn sửa chữa đầy đủ.
Triệu chứng liên quan
The bit passed initial insertion, but backs out, falls free, or loses drive while the chuck body stays secure.
The bit passed initial insertion, but backs out, falls free, 1. Release the trigger, remove the pack, and inspect the bit shank and retention
Bao gồm trong hướng dẫn đầy đủ
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Trang công khai chỉ hiển thị bản xem trước. Mua hướng dẫn đầy đủ để tải toàn bộ các bước sửa chữa, sơ đồ và quy trình xác minh.