failure mode
FM-22 BIT BINDS, TOOL STALLS, TWISTS, OR STOPS IN THE WORK
The accessory bit binds, causing the tool to stall, twist sharply, or stop unexpectedly in the work.
Tanı özeti
The accessory bit binds, causing the tool to stall, twist sharply, or stop unexpectedly in the work.
Olası Kök Nedenler
- Bit or fastener is damaged, dull, or wrong for the task
- Tool is off-axis or the work is not secured
- Pilot hole or clearance is inadequate
- Load exceeds the tool, battery, or accessory capability
Hızlı Kontroller
- The correct accessory drives straight without binding, stalling, or uncontrolled reaction.
Onarım Önizlemesi
1.
Bu, tam onarım kılavuzunda yer alan sorun giderme rehberinin bir önizlemesidir.
İlgili belirtiler
The accessory catches or stops in the material and the tool reacts sharply in the hand.
The accessory catches or stops in the material and the 1. Release the trigger and control the tool until all motion stops.
Tam kılavuza dahil
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Herkese açık sayfalar yalnızca önizleme gösterir. Eksiksiz onarım adımları, diyagramlar ve doğrulama prosedürlerini indirmek için tam kılavuzu satın alın.