FM-06: STRÖMAVBROTT NÄR VERKTYGET ELLER BATTERY FLYTTAS

rörelseberoende strömavbrott.

• Dry contamination, wear, or damage at the battery contacts
• Battery shell or latches allow electrical movement despite physical retention
• Tool contact block or internal wiring is loose
• Trigger, direction switch, brush, or motor connection is intermittent

1. Ordinary handling no longer interrupts power, or the internal intermittent path is conclusively routed to service.

1. Repeat with a known-good compatible battery to separate a pack-side intermittent condition from the tool-side path.
2. With the chuck empty, make one brief no-load test while changing only normal hand orientation; do not flex, strike, shim, or hold the pack in place.
3. If a proven battery still causes cutout with ordinary movement, remove it and route the contact block, wiring, switch, brush, or motor path to service.
4. Release the trigger and remove the battery before inspecting the contacts, latches, stem, and tool rail path for heat, burning, looseness, or impact damage.
5. Dry-clean the accessible contacts and latch surfaces, then install the original pack until the release latch pass an unpowered pull test.

Det här är en förhandsgranskning av felsökningsvägledningen i den fullständiga reparationsmanualen.

• battery förblir fysiskt spärrad, men motor, LED eller båda slocknar och återkommer när verktyget eller battery flyttas genom vanlig arbetsorientering.

  battery förblir fysiskt låst, men motor, LED eller 1. Släpp avtryckaren och ta bort battery innan du inspekterar kontakterna,

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentliga sidor visar endast en förhandsgranskning. Köp den fullständiga manualen för att ladda ner alla reparationssteg, diagram och verifieringsprocedurer.