failure mode
FM-16: FM-16 BIT WILL NOT RELEASE, OR A SHORT OR BROKEN BIT IS TRAPPED
The chuck collar pulls but the bit will not come out, or a short or broken bit piece is recessed inside the chuck.
Diagnostisk översikt
The chuck collar pulls but the bit will not come out, or a short or broken bit piece is recessed inside the chuck.
Troliga grundorsaker
- Bit is shorter than 2 inches and sits too deep
- Shank is burred, twisted, or impact-swaged
- Detent remains loaded by side pressure
- Collar, ball, or spring is damaged
Snabbkontroller
- The old bit is removed safely and a correct replacement locks and releases normally.
Reparationsförhandsgranskning
1.
Det här är en förhandsgranskning av felsökningsvägledningen i den fullständiga reparationsmanualen.
Vanliga åtgärder
- Eye protection
Relaterade symtom
The collar pulls, but the bit will not come out, or a short/broken piece is recessed in the chuck.
The collar pulls, but the bit will not come out, or a 1. Remove the pack; point the nose down; hold the collar open and pull only a
Ingår i fullständig manual
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Offentliga sidor visar endast en förhandsgranskning. Köp den fullständiga manualen för att ladda ner alla reparationssteg, diagram och verifieringsprocedurer.