failure mode
FM-22 BIT BINDS, TOOL STALLS, TWISTS, OR STOPS IN THE WORK
The accessory bit binds, causing the tool to stall, twist sharply, or stop unexpectedly in the work.
Diagnostisk översikt
The accessory bit binds, causing the tool to stall, twist sharply, or stop unexpectedly in the work.
Troliga grundorsaker
- Bit or fastener is damaged, dull, or wrong for the task
- Tool is off-axis or the work is not secured
- Pilot hole or clearance is inadequate
- Load exceeds the tool, battery, or accessory capability
Snabbkontroller
- The correct accessory drives straight without binding, stalling, or uncontrolled reaction.
Reparationsförhandsgranskning
1.
Det här är en förhandsgranskning av felsökningsvägledningen i den fullständiga reparationsmanualen.
Relaterade symtom
The accessory catches or stops in the material and the tool reacts sharply in the hand.
The accessory catches or stops in the material and the 1. Release the trigger and control the tool until all motion stops.
Ingår i fullständig manual
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Offentliga sidor visar endast en förhandsgranskning. Köp den fullständiga manualen för att ladda ner alla reparationssteg, diagram och verifieringsprocedurer.