Поиск руководств по ремонту

Найдите руководства, мануалы, симптомы и коды ошибок во всей базе знаний.

Руководства

Симптомы

The charger green LED does not flash, never becomes steady, or the battery remains discharged.
BATTERY WILL NOT CHARGE
Pemicu macet, gagal kembali, atau motor tetap menyala setelah dilepaskan.
TRIGGER STICKS, WILL NOT RETURN, OR MOTOR KEEPS RUNNING
A seated battery shows no charge response, or charge never reaches a usable full state.
Pakiet nie ładuje się lub lampka ładowarki pozostaje wyłączona lub pokazuje nienormalny czerwony wzór.
Laddaren startar inte eller slutför inte laddning, eller dess gröna lampa beter sig onormalt.
The trigger binds or does not spring fully OFF, or the motor keeps running after the trigger is released.
Battery or charger feels warm
THE BATTERY OR CHARGER WILL NOT BEGIN OR COMPLETE A CHARGE
A compatible V20 battery starts onto the tool rails but binds before reaching the normal seated and latched position.
A straight bit or the empty chuck shows repeatable side-to-side runout at low no-load speed after the bit has been centered and tightened correctly.
battery остаётся физически зафиксированным, но motor, светодиод или оба отключаются и включаются при перемещении инструмента или battery в обычном рабочем положении.
motor слышен при работе, но патрон остаётся неподвижным, останавливается самостоятельно или свободно вращается без передачи нормального привода в любом полностью выбранном диапазоне скорости.
The chuck jaws open and close normally, but a straight compatible bit rotates or pulls out during moderate drilling or driving.
The chuck still rotates, but a new mechanical grind, knock, scrape, tight spot, or severe vibration remains with the bit removed and is not ordinary motor or brake sound.
The collar moves and holds a low numbered setting, but the clutch does not ratchet before a test fastener is overdriven in suitable scrap material.
The collar moves normally, but the clutch ratchets before a suitable fastener reaches normal depth at appropriate settings, or it audibly slips when drill mode is correctly selected.
The direction selector is centered, but the trigger still depresses enough to start the motor or the center position cannot reliably prevent activation.
The drill sounds and rotates normally with no load, does not stall, overheat, slip, or vibrate abnormally, yet a corrected drilling or fastening task progresses much more slowly than expected.

Режимы неисправностей

part