FM-17: FM-17 THE BIT SLIPS OR PULLS OUT UNDER LOAD

FM-17 THE BIT SLIPS OR PULLS OUT UNDER LOAD

• Bit did not pass a firm tug test
• Shank groove or hex corners are worn
• Wrong-shank or non-impact accessory is fitted
• Detent, ball, spring, or collar is worn

1. The bit remains locked through a controlled drive and then releases normally.

1.

Это предпросмотр руководства по устранению неисправностей из полного руководства по ремонту.

• The bit passed initial insertion, but backs out, falls free, or loses drive while the chuck body stays secure.

  The bit passed initial insertion, but backs out, falls free, 1. Release the trigger, remove the pack, and inspect the bit shank and retention

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

На публичных страницах показан только предпросмотр. Купите полное руководство, чтобы скачать все шаги, схемы и процедуры проверки.