O tăietură la zero grade nu este pătrată prin material

Indicatorul de înclinare este setat la zero și talpa pare plată, dar tăietura finalizată nu este constant la 90 de grade față de suprafața de lucru.

• Zero-degree shoe calibration is out of adjustment
• Bevel lever is not fully locked or shoe moves during the cut
• Blade is bent, loose, or side-loaded
• Shoe is bent, dirty, or not resting flat on the work

1. An actual zero-bevel scrap cut measures square through the material and the locked setting repeats.

1. Release the trigger, wait for a full stop, remove the battery, set bevel to zero, and clean the shoe/blade reference surfaces.
2. Confirm a straight correctly clamped blade, a flat undamaged shoe, and a bevel lever that locks without movement.
3. Retract the lower guard with the battery removed, place the saw on its blade side, and compare the blade plate - not a tooth - to an accurate square agains
4. Adjust only the accessible 90-degree calibration screw by the official procedure, relock the bevel lever, and return the guard to normal operation.
5. - Make and square-check an actual supported scrap cut - if the setting will not calibrate or hold, stop and route the shoe, quadrant, pivot, and spindle align

Aceasta este o previzualizare a ghidului de depanare inclus în manualul complet de reparație.

• FM-21: Fm Dcs578 21

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Paginile publice afișează doar o previzualizare. Cumpără manualul complet pentru a descărca pașii completi de reparație, diagramele și procedurile de verificare.