Battery nu se va instala, nu se va fixa sau nu se va elibera de pe fierăstrău

Un acumulator care pare compatibil nu alunecă complet pe șine, nu rămâne fixat sau nu se eliberează când se apasă butonul de eliberare.

• Pack is misaligned, incompatible, swollen, or damaged
• Sawdust or a bent rail is obstructing travel
• Battery release button or latch is jammed, cracked, or not returning
• Handle rails or battery-interface housing are damaged

1. The pack slides on without force, clicks securely, cannot disengage unintentionally, and releases normally when the button is pressed.

1. Place the saw on a stable side surface, release the trigger, and do not force, hammer, or pry the pack.
2. Inspect the pack case, rails, latch, release button, and saw rails for debris, swelling, cracks, heat damage, or bent plastic.
3. Clean the rails dry, align the pack squarely, slide until it latches, or press the release fully and pull the pack straight out.
4. - Compare with a known-good compatible pack - if the tool rails, latch, release, or housing remain damaged or jammed, keep the saw out of service for authoriz

Aceasta este o previzualizare a ghidului de depanare inclus în manualul complet de reparație.

• FM-04: Fm Dcs578 04

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Paginile publice afișează doar o previzualizare. Cumpără manualul complet pentru a descărca pașii completi de reparație, diagramele și procedurile de verificare.