Lama se blochează, se înțepenește, se strânge sau fierăstrăul dă înapoi în tăiere

Lama este prinsă fizic sau încetinită de tăietură, fierăstrăul se ridică sau se deplasează înapoi spre operator, sau se încearcă repornirea cu dinții blocați în material.

• Workpiece is supported so the kerf closes and pinches the blade
• Blade is dull, dirty, bent, wrong, too deep, or twisted off the line
• Saw was started against the work or forced, turned, or backed in the cut
• Wet, knotty, treated, or unstable wood is loading the blade

1. The saw enters at full speed and completes a supported straight scrap cut without kerf closure, stall, twist, lift, or kickback.

1. Release the trigger immediately, hold the saw firmly until the blade stops and guard closes, then remove the battery before freeing the blade.
2. Support the work close to the cut so the cutoff cannot sag into the kerf, and remove nails, wire, unstable pieces, and binding forces.
3. - Inspect and replace a dull, dirty, bent, damaged, or wrong blade - set depth to about one-half tooth below the material and secure both adjustment levers.
4. Reposition the shoe flat and straight, bring the blade to full speed before contact, and feed at a rate that lets the blade cut without laboring or turning
5. - Make one supported scrap cut - if binding occurs with correct support, blade, depth, alignment, and feed, stop and route guard, shoe, spindle, and drive ali

Aceasta este o previzualizare a ghidului de depanare inclus în manualul complet de reparație.

• FM-18: Fm Dcs578 18

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Paginile publice afișează doar o previzualizare. Cumpără manualul complet pentru a descărca pașii completi de reparație, diagramele și procedurile de verificare.