failure mode
FM-15: O Trava-Lâmina Ou Hardware De Fixação Não Permite Remover Ou Fixar A Lâmina
O trava-lâmina não engata ou libera, o screw de fixação não gira corretamente, ou o screw e a arruela externa não conseguem fixar a lâmina durante a instalação.
Visão geral do diagnóstico
O trava-lâmina não engata ou libera, o screw de fixação não gira corretamente, ou o screw e a arruela externa não conseguem fixar a lâmina durante a instalação.
Causas prováveis
- Blade lock button is jammed, damaged, or being used incorrectly
- Clamping screw threads, wrench flats, spindle, or outer washer are damaged
- Sawdust or corrosion is packed in the clamp area
Verificações rápidas
- The blade lock engages only during hand rotation, the correct screw turns in the proper direction, the washer seats correctly, and the blade clamps firmly.
Prévia de reparo
- Remove the battery, set the saw on its side, and never press the blade lock while the saw is powered or use it as a brake.
- - Hand-turn the spindle while pressing the blade lock until it engages - use the blade wrench and remember the right-hand screw loosens counterclockwise and t
- - Remove only the clamping screw and outer washer, clean sawdust dry, and inspect the lock, screw, washer, spindle threads, and wrench flats for damage - do n
- Reassemble with the large flat face of the outer washer against the blade and the beveled side out, then tighten the screw firmly by the official sequence.
- If the lock will not engage/release or any clamp or spindle surface is stripped, cracked, rounded, or unable to hold torque, keep the battery out and use a
Esta é uma prévia da orientação de solução de problemas incluída no manual de reparo completo.
Correções comuns
- Caixa de engrenagens, engrenagens, rolamentos ou eixo
- Parafuso de fixação da lâmina ou arruela
- Trava da lâmina, chave da lâmina, braçadeira de screw e arruelas
- Caixa de engrenagens, engrenagens, rolamentos e eixo
- Lâmina de corte de madeira de 7-1/4 polegadas
Sintomas relacionados
O Trava-Lâmina Ou Hardware De Fixação Não Permite Remover Ou Fixar A Lâmina
O trava-lâmina não engata ou libera, o screw de fixação não gira corretamente, ou o screw e a arruela externa não conseguem fixar a lâmina durante a instalação.
Incluído no manual completo
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
As páginas públicas mostram apenas uma prévia. Compre o manual completo para baixar as etapas de reparo, diagramas e procedimentos de verificação completos.