failure mode
FM-15: Blokada ostrza lub elementy zaciskowe nie pozwalają na zdjęcie lub zabezpieczenie ostrza
Blokada ostrza nie włącza się lub nie zwalnia, zaciskający screw nie obraca się prawidłowo, lub screw i zewnętrzna podkładka nie mogą zabezpieczyć ostrza podczas montażu.
Przegląd diagnostyczny
Blokada ostrza nie włącza się lub nie zwalnia, zaciskający screw nie obraca się prawidłowo, lub screw i zewnętrzna podkładka nie mogą zabezpieczyć ostrza podczas montażu.
Prawdopodobne przyczyny
- Blade lock button is jammed, damaged, or being used incorrectly
- Clamping screw threads, wrench flats, spindle, or outer washer are damaged
- Sawdust or corrosion is packed in the clamp area
Szybkie sprawdzenia
- The blade lock engages only during hand rotation, the correct screw turns in the proper direction, the washer seats correctly, and the blade clamps firmly.
Podgląd naprawy
- Remove the battery, set the saw on its side, and never press the blade lock while the saw is powered or use it as a brake.
- - Hand-turn the spindle while pressing the blade lock until it engages - use the blade wrench and remember the right-hand screw loosens counterclockwise and t
- - Remove only the clamping screw and outer washer, clean sawdust dry, and inspect the lock, screw, washer, spindle threads, and wrench flats for damage - do n
- Reassemble with the large flat face of the outer washer against the blade and the beveled side out, then tighten the screw firmly by the official sequence.
- If the lock will not engage/release or any clamp or spindle surface is stripped, cracked, rounded, or unable to hold torque, keep the battery out and use a
To jest podgląd wskazówek diagnostycznych zawartych w pełnej instrukcji naprawczej.
Typowe naprawy
- Obudowa przekładni, koła zębate, łożyska lub wrzeciono
- Śruba mocująca ostrze screw lub podkładka
- Blokada tarczy, klucz do tarczy, zaciskowy screw i podkładki
- Obudowa przekładni, koła zębate, łożyska i wrzeciono
- Tarcza do cięcia drewna 7-1/4 cala
Powiązane objawy
Blokada ostrza lub elementy zaciskowe nie pozwalają na zdjęcie lub zabezpieczenie ostrza
Blokada ostrza nie włącza się lub nie zwalnia, zaciskający screw nie obraca się prawidłowo, lub screw i zewnętrzna podkładka nie mogą zabezpieczyć ostrza podczas montażu.
Zawarte w pełnej instrukcji
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Strony publiczne pokazują tylko podgląd. Kup pełną instrukcję, aby pobrać kompletne kroki naprawcze, schematy i procedury weryfikacji.