FM-03: Sagen starter, deretter kutter ut med avtrekkeren holdt

Sagen starter, men stopper mens avtrekkeren holdes inne, under belastning eller uten belastning.

• Pack protection opened for charge or temperature
• Blade was pinched, bound, or overloaded by the cut
• Pack is loose or the contacts are intermittent under vibration
• Blocked vents or heavy loading caused thermal protection
• Internal control or motor fault

1. The saw runs steadily at no load and through a controlled supported cut.

1. Release the trigger and wait until the blade stops completely.
2. Remove the battery, free the saw from the work, and clear any pinching or blocked vents.
3. Install a charged known-good pack and run the saw briefly at no load.
4. - If no-load cutout repeats, keep the saw out of service - if stable, correct blade, support, and feed.

Dette er en forhåndsvisning av feilsøkingsveiledningen som er inkludert i den fullstendige reparasjonsmanualen.

• Motor, girkasse eller spindel
• FLEXVOLT battery grensesnitt
• Elektronisk module og motor
• Kompatibel FLEXVOLT battery

• Sagen starter, deretter kutter ut med avtrekkeren holdt

  Sagen starter, men stopper mens avtrekkeren holdes inne, under belastning eller uten belastning.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser bare en forhåndsvisning. Kjøp den fullstendige manualen for å laste ned fullstendige reparasjonstrinn, diagrammer og verifiseringsprosedyrer.