FM-06: MOTOR GÅR, MEN BLADET VIL IKKE SNU

FM-06 MOTOR GÅR, MEN BLADET VIL IKKE SNU

• Blade bolt or outer washer is loose or assembled wrong
• Blade is not seated on the spindle
• Blade bolt or washer is damaged
• Gear train or spindle has stripped or broken
• Spindle lock damage is interfering with the drive

1. The securely mounted blade follows the spindle immediately and runs without slipping.

1. Inspect blade seating, rotation direction, outer washer, and the left-hand blade bolt; engage the spindle lock only while stopped and tighten the bolt counterclockwise.
2. With the battery removed, rotate the blade gently by hand and verify the spindle turns with it without clamp slip, grinding, or abnormal free play.
3. If the motor runs but the correctly clamped spindle or blade still does not drive, stop testing and have the gear train, spindle, and lock serviced.
4. Release the trigger, wait for all motion to stop, remove the battery, and do not run the saw again until the blade drive is checked.

Dette er en forhåndsvisning av feilsøkingsveiledningen som er inkludert i den fullstendige reparasjonsmanualen.

• Motor går, men bladet står stille

  Motor går, men bladet står stille Bladklemme, gir eller spindeldrift-feil; bruk FM-06.

• motor kan høres gå, men bladet står stille, starter sent eller glir i stedet for å følge motor.

  motor kan høres kjøre, men bladet står stille, starter sent eller glir i stedet for å følge motor.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser bare en forhåndsvisning. Kjøp den fullstendige manualen for å laste ned fullstendige reparasjonstrinn, diagrammer og verifiseringsprosedyrer.