FM-08: KUTTING ER SAKTE, KILER SEG, STOPPER, BRENNER ELLER FLISER

Problemer med kutteytelse hvor bladet roterer, men sagen mater dårlig, stopper, brenner tre eller fliser overdrevent under normale kutt. Umiddelbar stopp anbefales for å forhindre skade eller personskade.

• Blade is dull, damaged, dirty, or wrong for wood
• Cut depth is excessive
• Kerf closes because the work is unsupported
• Depth or bevel lock is loose
• Saw is forced before full speed or against the cut line

1. The saw advances smoothly through supported wood with a clean kerf, normal motor sound, and no burning, stall, or excessive splintering.

1. Set depth so about one tooth projects below the work, lock depth and bevel, and support and clamp the work so the kerf cannot close on the blade.
2. Let the blade reach full speed, keep the shoe flat, and guide with gentle pressure on scrap; persistent overload or poor cutting routes to FM-05 or FM-07.
3. Release the trigger, hold the saw still until the blade stops, remove it from the cut only after the stop, and remove the battery.
4. Fit a clean sharp wood-cutting blade of the correct diameter, bore, and speed rating; remove sap buildup and reject damaged or abrasive wheels.

Dette er en forhåndsvisning av feilsøkingsveiledningen som er inkludert i den fullstendige reparasjonsmanualen.

• Blad, ytre skive og venstregjenget bolt
• Sko, dybdehendel og dybdeskala

• Bladet roterer, men sagen mater dårlig, stopper i kuttet, brenner treet, splitter for mye eller overbelastes under et vanlig kutt.

  Bladet roterer, men sagen mater dårlig, stopper i kuttet, brenner treet, splitter for mye eller overbelastes under et vanlig kutt.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser bare en forhåndsvisning. Kjøp den fullstendige manualen for å laste ned fullstendige reparasjonstrinn, diagrammer og verifiseringsprosedyrer.