FM-23: BITTEN GLIR ELLER DRAS UT AV CHUCKEN

FM-23

• Bit was not inserted straight or enough jaw length was not engaged
• Chuck was not tightened firmly by hand
• Bit shank is oily, undersized, worn, or damaged
• Chuck jaws or internal scroll are worn despite normal movement

1. A sound bit remains centered and retained through a moderate test, or chuck wear is proven.

1. Tighten the single-sleeve chuck firmly by hand using the spindle lock, then pull-test the bit before power.
2. Make one moderate controlled work test; if a sound correctly tightened bit still slips, route the chuck for service or supported replacement.
3. Release the trigger, remove the battery, and remove or catch the loose bit before it can fall.
4. Clean the bit shank and chuck jaws dry, reject a bent or damaged bit, and insert a sound bit straight with all three jaws centered.

Dette er en forhåndsvisning av feilsøkingsveiledningen som er inkludert i den fullstendige reparasjonsmanualen.

• Borbit

• Chuckkjevene åpner og lukker normalt, men en rett kompatibel bit roterer eller dras ut under moderat boring eller skrutrekking.

  Kjeftens kjever åpner og lukker normalt, men et rett 1. Slipp avtrekkeren, fjern battery, og fjern eller fang det løse boret før

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Offentlige sider viser bare en forhåndsvisning. Kjøp den fullstendige manualen for å laste ned fullstendige reparasjonstrinn, diagrammer og verifiseringsprosedyrer.