failure mode
FM-16: FM-16 BIT WILL NOT RELEASE, OR A SHORT OR BROKEN BIT IS TRAPPED
The chuck collar pulls but the bit will not come out, or a short or broken bit piece is recessed inside the chuck.
Diagnostisk oversikt
The chuck collar pulls but the bit will not come out, or a short or broken bit piece is recessed inside the chuck.
Sannsynlige rotårsaker
- Bit is shorter than 2 inches and sits too deep
- Shank is burred, twisted, or impact-swaged
- Detent remains loaded by side pressure
- Collar, ball, or spring is damaged
Raske kontroller
- The old bit is removed safely and a correct replacement locks and releases normally.
Reparasjonsforhåndsvisning
1.
Dette er en forhåndsvisning av feilsøkingsveiledningen som er inkludert i den fullstendige reparasjonsmanualen.
Vanlige løsninger
- Eye protection
Relaterte symptomer
The collar pulls, but the bit will not come out, or a short/broken piece is recessed in the chuck.
The collar pulls, but the bit will not come out, or a 1. Remove the pack; point the nose down; hold the collar open and pull only a
Inkludert i den fullstendige manualen
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Offentlige sider viser bare en forhåndsvisning. Kjøp den fullstendige manualen for å laste ned fullstendige reparasjonstrinn, diagrammer og verifiseringsprosedyrer.