증상
문서화된 증상을 탐색하고 검색 결과에서 관련 수리 가이드로 이동하세요.
The tool-free blade-clamp release lever will not reach full open or close securely.
관련 매뉴얼 0개
가이드 찾기 →
The robot powers down before the job is complete and gives no repeatable beep count.
관련 매뉴얼 0개
가이드 찾기 →
Forward or reverse will not engage, or the center position will not lock the trigger.
관련 매뉴얼 0개
가이드 찾기 →
With the clamp lever working, a correct blade will not enter fully or fails the hand tug-check.
관련 매뉴얼 0개
가이드 찾기 →
The pack will not click into the rear bay or springs loose during handling.
관련 매뉴얼 0개
가이드 찾기 →
The collar will not align or hold, or screwdriving clutch cut-off is absent or premature.
관련 매뉴얼 0개
가이드 찾기 →
The robot repeatedly reverses, circles, or turns away on a clear, level hard floor after placement causes are ruled out.
관련 매뉴얼 0개
가이드 찾기 →
The clamp lever opens normally, but the installed blade remains trapped in the front clamp.
관련 매뉴얼 0개
가이드 찾기 →
The chuck sleeve will not turn enough to move the jaws or admit a normal straight bit.
관련 매뉴얼 0개
가이드 찾기 →
The robot cancels a mission for a navigation problem or ends somewhere other than the Home Base after route and map state are ruled out.
관련 매뉴얼 0개
가이드 찾기 →
The robot stops or will not proceed and reports one beep after the two-tone distress sound.
관련 매뉴얼 0개
가이드 찾기 →
The chuck opens and closes, but the bit slips, pulls out, or ejects during normal work.
관련 매뉴얼 0개
가이드 찾기 →
The job ends with a docking problem or the robot cannot find the Home Base after placement, clearance, and map-start checks are corrected.
관련 매뉴얼 0개
가이드 찾기 →
The shoe will not pivot freely, is bent or loose, or will not sit firmly against the work.
관련 매뉴얼 0개
가이드 찾기 →
The robot refuses to start and reports two beeps after the two-tone distress sound.
관련 매뉴얼 0개
가이드 찾기 →
A straight bit stays clamped but rotates off-center, or the chuck body has visible play.
관련 매뉴얼 0개
가이드 찾기 →
The robot is charged but cannot drive off the Home Base when a job begins after clearance and placement are proven.
관련 매뉴얼 0개
가이드 찾기 →
The robot will not start, or stops after a pad falls off, and reports three beeps.
관련 매뉴얼 0개
가이드 찾기 →
The blade strokes steadily but cuts slowly, stalls easily, or needs excessive feed force.
관련 매뉴얼 0개
가이드 찾기 →
The robot stops with Error 68 because its camera failed during the cleaning job.
관련 매뉴얼 0개
가이드 찾기 →