수리 가이드 검색

지식 베이스에서 수리 가이드, 매뉴얼, 증상 및 오류 코드를 찾으세요.

매뉴얼

증상

A correct-looking bit will not enter fully or can be pulled out after the collar is released.
Zincir veya çubuk çalışmasından sonra kapak tam oturmaz, çubuk hizalanmaz veya kilit düğmesi doğru başlamaz.
A compatible-looking pack will not slide fully into the handle, click, or stay retained.
battery가 장착 위치에 도달했으나 해제 버튼을 누르지 않고도 빠지거나 들리거나 유지력을 잃음. 보이는 팩 및 충전기 구조는 온전함.
척이 멈추고 battery가 제거된 상태에서 척을 손으로 돌려 기어를 정렬해도 상단 선택기를 1단 또는 2단 범위로 완전히 이동할 수 없음.
The cool tool starts, then stops during a brief no-load test or light fastening task before heat builds.
The drill stalls, binds, shuts down, or has low power
With the battery removed from every tool and charger, the charge-status button cannot be pressed normally, remains depressed or has broken away.
Klämspaken öppnas normalt, men det installerade bladet sitter fast i framklämman.
Spoušť se plně nevrací ven, nebo motor/kotouč běží i po uvolnění spouště.
Narzędzie, akumulator lub ładowarka nagrzewa się nadmiernie lub ochrona wielokrotnie zatrzymuje pracę.
A straight bit or socket visibly orbits, shakes, or runs off-center during a brief no-load test.
Chłodna wiertarka zaczyna działać, a następnie zatrzymuje się podczas krótkiego testu bez obciążenia lub lekkiej pracy.
Efter att avtryckaren släppts fortsätter bladet att slå märkbart längre än normalt.
Uchwyt otwiera się i zamyka, ale wiertło ślizga się, wypada lub jest wyrzucane podczas normalnej pracy.
With no fastener load, the bare or correctly fitted output sounds harsh, binds, knocks, or shakes abnormally.
Bright repeated arcing or sharp crackling is visible at the rear vents while the tool runs.
Kerah menarik tetapi aksesori yang terpasang tidak keluar, atau potongan patah terjebak di chuck.
The quick-release collar is stuck, has limited travel, or does not spring back after it is pulled.
Den löpande sågen hoppar, vibrerar mot arbetsstycket, fastnar eller sparkar bakåt eller åt sidan.

고장 모드

part

차갑게 충전된 battery