수리 가이드 검색

지식 베이스에서 수리 가이드, 매뉴얼, 증상 및 오류 코드를 찾으세요.

모델

매뉴얼

증상

Den kalla sågen startar, men stannar under ett kort tomgångstest eller lätt snitt innan värme byggs upp.
Starts, then stops while cool
The trigger returns normally and power drops, but the anvil repeatedly coasts instead of stopping promptly.
The motor can be heard, but the front output remains still in both directions with the bit removed.
The bit jams, the motor stalls, or the drill twists sharply in the hands during work.
Bladet lämnar linjen, böjs överdrivet, böjs eller går av under en annars kontrollerad skärning.
The drill stops early or gives far less runtime than expected without unusual heat.
The drill or battery becomes rapidly or severely hot, or little cooling air can move through the tool vents.
The quick-release collar is stuck, has limited travel, or does not spring back after it is pulled.
The trigger lights the work area, but the motor stays silent and the quick-release chuck does not turn.
The drill stalls, binds, shuts down, or has low power
LED 작업등이 켜지지 않거나 비정상적으로 켜져 있음
THE BATTERY OR CHARGER WILL NOT BEGIN OR COMPLETE A CHARGE
THE BATTERY WILL NOT SEAT, LATCH, RELEASE, OR STAY SECURE
The torque collar binds, will not stay on a setting, or the clutch slips or locks at every position.
Chłodna wiertarka zaczyna działać, a następnie zatrzymuje się podczas krótkiego testu bez obciążenia lub lekkiej pracy.
Chuck clicks while tightening
Wiertarka działa stabilnie, ale wierci wolno lub nie może wkręcić normalnego elementu mocującego przy prawidłowym ustawieniu.
BATTERY WILL NOT CHARGE
Bezpieczne proste wiertło i czysta praca nie eliminują głośnego dźwięku lub drgań bez obciążenia.

고장 모드

part