FM-08: 절단이 느리거나 걸리거나 멈추거나 타거나 갈라짐

블레이드는 회전하지만 톱이 제대로 공급되지 않거나 멈추거나 목재가 타거나 과도하게 갈라지는 절단 성능 문제. 손상이나 부상을 방지하기 위해 즉시 사용 중지 권장.

• Blade is dull, damaged, dirty, or wrong for wood
• Cut depth is excessive
• Kerf closes because the work is unsupported
• Depth or bevel lock is loose
• Saw is forced before full speed or against the cut line

1. The saw advances smoothly through supported wood with a clean kerf, normal motor sound, and no burning, stall, or excessive splintering.

1. Set depth so about one tooth projects below the work, lock depth and bevel, and support and clamp the work so the kerf cannot close on the blade.
2. Let the blade reach full speed, keep the shoe flat, and guide with gentle pressure on scrap; persistent overload or poor cutting routes to FM-05 or FM-07.
3. Release the trigger, hold the saw still until the blade stops, remove it from the cut only after the stop, and remove the battery.
4. Fit a clean sharp wood-cutting blade of the correct diameter, bore, and speed rating; remove sap buildup and reject damaged or abrasive wheels.

이것은 전체 수리 매뉴얼에 포함된 문제 해결 안내의 미리보기입니다.

• 블레이드, 외부 와셔 및 좌회전 bolt
• 슈, 깊이 레버 및 깊이 눈금

• The blade turns, but the saw feeds poorly, stalls in the kerf, burns the wood, splinters excessively, or overloads during an ordinary cut.

  The blade turns, but the saw feeds poorly, stalls in the kerf, burns the wood, Release the trigger, hold the saw still until the blade stops, remove it from the cut only after FM-08

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

공개 페이지에는 미리보기만 표시됩니다. 전체 수리 단계, 다이어그램 및 검증 절차를 다운로드하려면 전체 매뉴얼을 구매하세요.