FM-28: 무부하 정상 작동에도 불구하고 드릴링 또는 고정이 느림

FM-28

• Bit is dull, wrong for the material, or mismatched to the fastener
• Speed range or clutch setting is wrong for the task
• Work is unsupported, pressure is misdirected, or chips are not clearing
• Battery has reduced capacity under work load
• Internal torque output is reduced without obvious no-load loss

1. The corrected task progresses at normal speed, or the bit, battery, setup, or internal output source is conclusively separated.

1. Remove the battery and inspect or replace the bit before changing any tool setting.
2. Remove the battery and inspect or replace the bit before changing settings FM-28

이것은 전체 수리 매뉴얼에 포함된 문제 해결 안내의 미리보기입니다.

• The drill sounds and rotates normally with no load, does not stall, overheat, slip, or vibrate abnormally, yet a corrected drilling or fastening task progresses much more slowly than expected.

  The drill sounds and rotates normally with no load, does not 1. Remove the battery and inspect or replace the bit before changing any tool

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

공개 페이지에는 미리보기만 표시됩니다. 전체 수리 단계, 다이어그램 및 검증 절차를 다운로드하려면 전체 매뉴얼을 구매하세요.