failure mode
FM-13: FM-13 BATTERY가 무부하 상태에서 공구를 작동하지만 일반 부하 시 종료됨
FM-13.
진단 개요
FM-13.
예상 근본 원인
- Excessive internal resistance causes voltage sag
- One weak cell group triggers protection
- Contacts or power rails cannot carry normal current
- The tool task or accessory is actually overloaded
빠른 점검
- The battery completes the matched ordinary task without protection shutdown, or repeatable load-only failure is proven.
수리 미리보기
1.
이것은 전체 수리 매뉴얼에 포함된 문제 해결 안내의 미리보기입니다.
일반적인 수리
- 정상 호환 공구
관련 증상
The pack starts and runs a known-good compatible tool at no load, but output stops promptly during an ordinary matched task that a known-good battery completes.
The pack starts and runs a known-good compatible tool at no 1. Stop the task when output cuts off and remove the pack; inspect for unusual heat,
전체 매뉴얼에 포함
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
공개 페이지에는 미리보기만 표시됩니다. 전체 수리 단계, 다이어그램 및 검증 절차를 다운로드하려면 전체 매뉴얼을 구매하세요.