model
GBA18V40
GBA18V40은 Bosch 및 AMPShare 18V 무선 공구용으로 설계된 Bosch CORE18V 시리즈의 4.0 Ah, 18V 리튬이온 battery입니다. Bosch 독점 CoolPack 2.0 냉각 기술, 고해상도 충전 상태 표시기, 전자 보호 기능을 갖추어 성능과 안전을 최적화합니다.
0% Reported Successful Repair
Get the Full Repair Manual — save $120–$140
모델 세부 정보
모델 번호: GBA18V40
다른 이름으로도 알려진: Bosch Power Tools, Bosch CORE18V, Bosch 18V Battery, GBA18V40 CORE18V 4 Ah Advanced Power Battery, GBA18V40
증상
- The battery is cool and dry but the outer shell is cracked, split, punctured, missing a piece, or open at a seam, with no smoke, liquid, swelling, odor or dangerous heat.
The battery is cool and dry but the outer shell is cracked, split, 1. Remove the pack from every device and place the cool dry battery on a clear
- The pack is fully seated, the release button is pressed, and the battery still cannot be slid out without excessive force.
The pack is fully seated, the release button is pressed, and the 1. Let the pack and receiver cool, support both so neither hangs from the latch, and
- The battery shows a credible high charge or has just completed a proven charge, remains fully latched and still gives no response in a known-good compatible tool while stationary.
The battery shows a credible high charge or has just 1. Remove the pack, screen for damage or heat, and dry-clean only the accessible
- A compatible charger continues to report its temperature-delay state after the battery has stabilized at room temperature and the charger works normally with another compatible battery.
A compatible charger continues to report its temperature-delay 1. Remove the pack and let it stabilize naturally at room temperature on a clear
- The battery reaches the normal seated position, but the release latch does not retain it and the pack can slide away without pressing the release button.
The battery reaches the normal seated position, but the 1. Support the receiver and remove the unretained battery before it can fall,
- With the pack removed and cool, one or more accessible power, signal or temperature contacts are visibly bent, pushed in, pitted, loose or corroded, with no active heat, smoke, liquid or melting.
With the pack removed and cool, one or more accessible 1. Remove the battery from all devices and place it on a nonconductive surface
- The pack starts and runs a known-good compatible tool at no load, but output stops promptly during an ordinary matched task that a known-good battery completes.
The pack starts and runs a known-good compatible tool at no 1. Stop the task when output cuts off and remove the pack; inspect for unusual heat,
- The cool dry battery shell appears closed, but a new loose rattle, clunk or shifting movement is heard inside after a drop or impact, with no swelling, liquid, smoke, odor or heat.
The cool dry battery shell appears closed, but a new loose 1. Remove the pack from every device and place it on a clear nonflammable surface.
- GBA18V40이 수신 레일에 걸리기 시작하지만 정상적인 장착 및 걸림 위치에 도달하기 전에 걸림.
GBA18V40이 수신기 레일에 걸리기 시작하지만 정상적으로 자리 잡고 걸쇠가 걸리기 전에 걸립니다. 1. 비틀거나 치거나 지렛대 사용 없이 강제로 밀지 말고 걸린 battery을(를) 수신기에서 곧바로 빼내십시오.
- Battery repeatedly overheats or protection-stops during light use
FM-16 BATTERY REPEATEDLY OVERHEATS OR FM-22 ACTIVE BATTERY HAZARD - SWELLING, LIQUID,
- Battery loses charge rapidly while stored disconnected
FM-15 BATTERY LOSES CHARGE RAPIDLY WHILE STORED FM-21 A NEW INTERNAL RATTLE OR LOOSE MOVEMENT IS
- A known-good compatible charger begins its normal charging cycle, but the cycle repeatedly stops, restarts, faults, or continues abnormally without reaching completion.
A known-good compatible charger begins its normal charging 1. Remove the pack when the abnormal cycle appears and inspect for heat, liquid,
고장 모드
- FM-22 활성 BATTERY 위험 - 부풀음, 액체, 연기, 불꽃, 용융, 냄새 또는 위험한 열
battery가 충전, 사용 또는 보관 중 부풀음, 누출, 연기, 불꽃, 용융, 강한 냄새 또는 위험한 열과 같은 활성 위험 징후를 보임.
- FM-07: FM-07 팩을 제거하고 충전을 반복하기 전에 위험 여부를 확인하십시오.
팩을 제거하고 위험 여부를 확인한 후 충전을 반복하십시오.
- CHARGE-STATUS INDICATOR GIVES NO RESPONSE AFTER A CONFIRMED FULL CHARGE
CHARGE-STATUS INDICATOR GIVES NO RESPONSE AFTER A CONFIRMED FULL CHARGE
- FM-10: FM-10 충전기는 완전 충전을 보고하지만 BATTERY에는 거의 사용 가능한 에너지가 없음
충전기는 완전 충전을 표시하지만 battery는 거의 사용 가능한 에너지가 없으며 공구를 짧게 또는 전혀 작동시키지 못함.
- FM-16: FM-16 BATTERY가 가벼운 사용 중 반복적으로 과열되거나 보호 기능이 작동함
battery가 실온에서 가벼운 간헐적 사용 중 반복적으로 과열되거나 보호 차단을 유발함.
- FM-05: 충전 상태 표시기가 반응하지 않음
충전 상태 표시기가 반응하지 않음
관련 문제 해결
Common symptoms
- The battery is cool and dry but the outer shell is cracked, split, punctured, missing a piece, or open at a seam, with no smoke, liquid, swelling, odor or dangerous heat.
- The pack is fully seated, the release button is pressed, and the battery still cannot be slid out without excessive force.
- The battery shows a credible high charge or has just completed a proven charge, remains fully latched and still gives no response in a known-good compatible tool while stationary.
- A compatible charger continues to report its temperature-delay state after the battery has stabilized at room temperature and the charger works normally with another compatible battery.
- The battery reaches the normal seated position, but the release latch does not retain it and the pack can slide away without pressing the release button.
- With the pack removed and cool, one or more accessible power, signal or temperature contacts are visibly bent, pushed in, pitted, loose or corroded, with no active heat, smoke, liquid or melting.
- The pack starts and runs a known-good compatible tool at no load, but output stops promptly during an ordinary matched task that a known-good battery completes.
- The cool dry battery shell appears closed, but a new loose rattle, clunk or shifting movement is heard inside after a drop or impact, with no swelling, liquid, smoke, odor or heat.
- GBA18V40이 수신 레일에 걸리기 시작하지만 정상적인 장착 및 걸림 위치에 도달하기 전에 걸림.
- Battery repeatedly overheats or protection-stops during light use