model
BAT414
GSR12V-140FCB22 키트에는 Bosch 12V 최대 리튬이온 2.0 Ah 실린더 battery 팩 BAT414가 포함되어 있으며, Bosch 12V 최대 무선 전동 공구용으로 설계되었습니다. 안전한 공구 부착을 위한 삽입 스템과 측면 해제 탭이 있는 밀폐 하우징이 특징입니다.
보고된 수리 성공률 0%
모델 세부 정보
모델 번호: BAT414
다른 이름으로도 알려진: Robert Bosch GmbH, Bosch Power Tools, GSR12V-140FCB22 Kit Battery (BAT414), BAT414
증상
- battery가 정상 초기 전원을 제공하지만 동일 작업에서 건강한 2.0 Ah Bosch 12V Max 팩보다 훨씬 빨리 방전됨.
battery는 정상 초기 전력을 제공하지만 동일한 일반 작업에서 비교 가능한 건강한 2.0 Ah Bosch {MEASUREMENT:0} Max 팩보다 훨씬 빨리 소모됩니다. 1. 의심되는 battery를 정상 실내 온도에서 지정된 충전기로 완전히 충전하고 충전기가 정의된 완전 상태에 도달했는지 확인하십시오.
- 외관상 이상 없고 완전히 삽입된 BAT414 팩이 호환 Bosch 12V Max 공구에서 출력이 전혀 없음.
외관상 이상이 없고 완전히 삽입된 BAT414 팩이 호환되는 Bosch {MEASUREMENT:0} Max 공구에서 사용 가능한 출력을 생성하지 않습니다. 1. 공구에서 battery를 제거하고 하우징, 삽입 스템, 해제 탭,
- The battery is actively smoking, hissing, venting gas, sparking, burning, melting, leaking, or rapidly escalating in temperature.
The battery is actively smoking, hissing, venting gas, sparking, burning, melting, leaking, 1. Move away immediately, keep other people and pets away, and do not touch, carry,
- battery가 움직이거나 잡히면 충전이 시작되거나 중지됨
이동, 들어 올림 또는 한 위치에 고정됨. FM-07
- 완전 충전된 팩이 공구나 충전기에 두지 않고 짧은 냉각 건조 보관 후 사용 불가능해짐.
완전히 충전된 팩이 도구나 충전기에 두지 않았음에도 짧은 냉각 및 건조 저장 후 사용할 수 없게 됩니다. 1. 지정된 충전기에서 팩을 완전히 충전하고 충전기와 도구에서 제거한 후 날짜와 시작 상태를 기록하십시오.
- The charger indication or charge cycle changes when the seated battery is touched, shifted, lifted, or held in one position.
The charger indication or charge cycle changes when the seated battery is touched, 1. Stop wiggling the battery, unplug the charger, and remove the pack so arcing or
- The pack is fully or partly engaged but cannot be removed by operating the normal release and pulling straight.
The pack is fully or partly engaged but cannot be removed by operating the normal 1. Turn the tool off or unplug the charger, secure the assembly on a stable surface, and
- A compatible tool starts normally, then loses all battery output suddenly during an ordinary task while the trigger remains commanded.
A compatible tool starts normally, then loses all battery output suddenly during an 1. Release the tool trigger immediately, wait for all motion to stop, remove the battery, and
- The stable pack is cracked, crushed, punctured, burned, deformed, swollen, corroded, or has damaged contacts, barriers, insertion stem, or release tabs.
The stable pack is cracked, crushed, punctured, burned, deformed, swollen, corroded, or 1. Remove the battery from every tool and charger only if safe, keep metal away from the
- 실린더 팩이 정상 장착 위치 전에 멈추거나 Bosch 12V Max 공구 또는 승인 충전기에서 비정상적인 힘이 필요함.
실린더 팩이 정상 장착 위치 전에 멈추거나 비정상적인 힘이 필요함 1. battery에 BAT414가 인쇄되어 있고 결합 제품이 Bosch 10.8V/12V 호환 Bosch 10.8V Max 도구 또는 승인된 충전기인지 확인하십시오.
- The pack inserts fully but one or both side release tabs do not retain it, or the pack can pull out without pressing both tabs.
The pack inserts fully but one or both side release tabs do not retain it, or the pack can 1. Stop using an interface that cannot retain the battery and remove the pack so it cannot
- The tool continues to run but power is continuously low, uneven, or surging instead of stopping completely.
The tool continues to run but power is continuously low, uneven, or surging instead of 1. Stop the tool, remove the battery, and inspect the pack for heat, swelling, damage,
고장 모드
- FM-05: FM-05 BATTERY가 보관 중 및 분리 상태에서 급속히 방전됨
battery가 보관 중 및 분리 상태에서 급속히 방전되어 짧은 냉각 건조 보관 후 사용 불가능해집니다.
- FM-06 BATTERY가 올바른 장착 및 온도 후 충전을 시작하거나 완료하지 않음
FM-06 BATTERY가 올바른 장착 및 온도 후 충전을 시작하거나 완료하지 않음
- FM-03: FM-03 공구 전력이 약하거나 급등하거나 완전 차단 없이 떨어짐
FM-03 공구 전력이 약하거나 급등하거나 완전 차단 없이 떨어짐
- FM-14: FM-14 BATTERY가 공구 또는 충전기에서 걸려 분리되지 않음
battery가 완전히 또는 부분적으로 장착되었으나 정상 해제 조작 및 직선으로 당겨도 분리되지 않음.
- FM-02: FM-02 공구가 시작되었다가 일반 부하 중 BATTERY 출력이 갑자기 끊김
FM-02 공구가 시작되었다가 일반 부하 중 BATTERY 출력이 갑자기 끊김
- FM-04: FM-04 완전 충전 확인 후 런타임이 정상보다 훨씬 짧음
FM-04 완전 충전 확인 후 런타임이 정상보다 훨씬 짧음
- FM-13 BATTERY가 장착 위치에 도달하지만 걸쇠가 걸리지 않거나 분리됨
battery가 완전히 삽입되었으나 한쪽 또는 양쪽 측면 해제 탭이 고정하지 않거나, 두 탭을 누르지 않고도 battery를 뺄 수 있음.
- FM-09: FM-09 활성 BATTERY 위험 - 연기, 쉬익거림, 배출, 불꽃, 화염, 용융 또는 누수
연기, 쉿 소리, 가스 배출, 불꽃, 화염, 녹음 또는 누출이 있는 활성 battery 위험으로 열 폭주 또는 심각한 손상 표시.
- FM-12 BATTERY가 호환 공구 또는 충전기에 완전히 삽입되지 않음
FM-12 BATTERY가 호환 공구 또는 충전기에 완전히 삽입되지 않음
- FM-11: FM-11 BATTERY가 젖었거나 잠겼거나 전도성 또는 부식성 액체에 노출됨
battery가 물 또는 전도성/부식성 액체에 노출되어 손상 또는 안전 문제 발생.
- FM-10: FM-10 하우징, 스템, 해제 탭, 단자, 장벽 또는 팩 본체가 손상되거나 팽창됨
FM-10 하우징, 스템, 해제 탭, 단자, 장벽 또는 팩 본체가 손상되거나 팽창됨
- FM-01: FM-01 키트 BATTERY가 정상 작동하는 Bosch 12V Max 공구에 전원을 공급하지 않음
완전히 삽입되고 외관상 이상 없는 BAT414 battery가 호환 Bosch 12V Max 공구에서 출력이 전혀 없음.
관련 문제 해결
Common symptoms
- battery가 정상 초기 전원을 제공하지만 동일 작업에서 건강한 2.0 Ah Bosch 12V Max 팩보다 훨씬 빨리 방전됨.
- 외관상 이상 없고 완전히 삽입된 BAT414 팩이 호환 Bosch 12V Max 공구에서 출력이 전혀 없음.
- The battery is actively smoking, hissing, venting gas, sparking, burning, melting, leaking, or rapidly escalating in temperature.
- battery가 움직이거나 잡히면 충전이 시작되거나 중지됨
- 완전 충전된 팩이 공구나 충전기에 두지 않고 짧은 냉각 건조 보관 후 사용 불가능해짐.
- The charger indication or charge cycle changes when the seated battery is touched, shifted, lifted, or held in one position.
- The pack is fully or partly engaged but cannot be removed by operating the normal release and pulling straight.
- A compatible tool starts normally, then loses all battery output suddenly during an ordinary task while the trigger remains commanded.
- The stable pack is cracked, crushed, punctured, burned, deformed, swollen, corroded, or has damaged contacts, barriers, insertion stem, or release tabs.
- 실린더 팩이 정상 장착 위치 전에 멈추거나 Bosch 12V Max 공구 또는 승인 충전기에서 비정상적인 힘이 필요함.