FM-17: FM-17 THE BIT SLIPS OR PULLS OUT UNDER LOAD

FM-17 THE BIT SLIPS OR PULLS OUT UNDER LOAD

• Bit did not pass a firm tug test
• Shank groove or hex corners are worn
• Wrong-shank or non-impact accessory is fitted
• Detent, ball, spring, or collar is worn

1. The bit remains locked through a controlled drive and then releases normally.

1.

이것은 전체 수리 매뉴얼에 포함된 문제 해결 안내의 미리보기입니다.

• The bit passed initial insertion, but backs out, falls free, or loses drive while the chuck body stays secure.

  The bit passed initial insertion, but backs out, falls free, 1. Release the trigger, remove the pack, and inspect the bit shank and retention

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

공개 페이지에는 미리보기만 표시됩니다. 전체 수리 단계, 다이어그램 및 검증 절차를 다운로드하려면 전체 매뉴얼을 구매하세요.