修理ガイドを検索

ナレッジベース全体で修理ガイド、マニュアル、症状、エラーコードを検索できます。

モデル

マニュアル

BLACK+DECKER LCS1020 Repair Manual

症状

The drill stops early or gives far less runtime than expected without unusual heat.
The accessory catches or stops in the material and the tool reacts sharply in the hand.
The motor runs normally, but the LED is dead, dim, or intermittent with trigger use.
The motor can be heard, but the front output remains still in both directions with the bit removed.
The trigger returns normally and power drops, but the anvil repeatedly coasts instead of stopping promptly.
Wiertarka działa stabilnie, ale wierci wolno lub nie może wkręcić normalnego elementu mocującego przy prawidłowym ustawieniu.
The drill stalls, binds, shuts down, or has low power
THE BATTERY OR CHARGER WILL NOT BEGIN OR COMPLETE A CHARGE
THE BATTERY WILL NOT SEAT, LATCH, RELEASE, OR STAY SECURE
THE DRILL WILL NOT START WITH A CHARGED KNOWN-GOOD BATTERY
The reservoir contains oil but the chain stays dry, the primer gives no visible result, or the bar oil path remains dry.
The saw cuts slowly, makes fine dust instead of chips, chatters in the kerf, or must be pushed hard despite judging sharpness.
A straight bit traces a visible circle at no load instead of rotating on a stable centerline.
WORKLIGHT COMES ON, BUT THE MOTOR WILL NOT START
A correct-looking bit will not enter fully or can be pulled out after the collar is released.
With the bit removed, the driver makes continuous abnormal grinding, knocking, or scraping.
Smoke, liquid, swelling, or major damage
A hand-tightened bit slips, visibly wobbles, or its tip runs off center when the drill turns.
BATTERY WILL NOT CHARGE
Bezpieczne proste wiertło i czysta praca nie eliminują głośnego dźwięku lub drgań bez obciążenia.

故障モード

part