failure mode
FM-04: ブレードの速度または切断力が正常以下
ブレードは回転するが、適切に支持された木材切断で速度や切断力が通常より低いです。
診断の概要
ブレードは回転するが、適切に支持された木材切断で速度や切断力が通常より低いです。
考えられる根本原因
- Battery charge or output is too low for the load
- Blade is dull, dirty, damaged, or unsuitable
- Blade rotation, size, arbor, or speed rating is incorrect
- Cut depth is excessive or feed pressure is too high
- Motor, bearing, or electronic drive fault
簡単チェック
- A clean supported test cut proceeds smoothly at normal blade speed.
修理プレビュー
- Release the trigger, remove the battery, and inspect the installed blade.
- Fit a clean sharp blade of the correct size, arbor, rotation, tooth count, and speed rating.
- Set depth so about one-half tooth projects below the work and support the material near the cut.
- - Test with a charged known-good pack and steady feed - if output stays low, seek service.
これは完全修理マニュアルに含まれているトラブルシューティングガイダンスのプレビューです。
一般的な修理方法
- 丸ノコ刃
- スピンドル、ギアケース、ブレード
- Motor、ギアケース、またはスピンドル
関連する症状
ブレードの速度または切断力が正常以下
ブレードは回転するが、適切に支持された木材切断で速度や切断力が通常より低いです。
完全版マニュアルに含まれています
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
公開ページはプレビューのみ表示されます。完全な修理手順、図解、確認手順をダウンロードするには完全版マニュアルを購入してください。