failure mode
FM-02: La sega si avvia, poi si spegne bruscamente sotto carico
La lama raggiunge la velocità, entra nel legno e poi tutta la rotazione alimentata si ferma bruscamente invece di rallentare o bloccarsi nella scanalatura.
Panoramica diagnostica
La lama raggiunge la velocità, entra nel legno e poi tutta la rotazione alimentata si ferma bruscamente invece di rallentare o bloccarsi nella scanalatura.
Cause probabili
- Electronic protection responded to overload, temperature, or deep battery discharge
- Battery is weak, undercharged, too hot, too cold, or moving on the rails
- Blade, depth, feed rate, or work support is creating excessive load
- Blocked vents or an internal electronic or motor fault repeats under load
Controlli rapidi
- The saw completes a controlled supported cut without abrupt powered shutdown, abnormal heat, or battery movement.
Anteprima riparazione
- Release the trigger, hold the shoe still until the blade stops and the lower guard closes, then remove the battery before freeing the saw.
- Let the tool and pack cool in a dry ventilated place, and inspect for heat damage, liquid, smoke, sparks, or a battery hazard before any retest.
- Free the blade from the kerf, correct work support and cutting depth, clean the vents dry, and replace a dull, damaged, dirty, or wrong blade.
- Install a known-good fully charged compatible pack and make one controlled light cut in supported scrap without forcing the saw.
- If the powered shutdown repeats while the blade remains free and the proven pack, blade, depth, support, and feed are correct, stop use and route the saw f
Questa è un'anteprima della guida alla risoluzione dei problemi inclusa nel manuale di riparazione completo.
Riparazioni comuni
- Leva profondità, guida e scala
- Ventilazioni di raffreddamento e involucro esterno
- Lama da taglio legno da 7-1/4 pollici
- Modulo elettronico module, motor brushless e freno elettrico
- Binari, contatti, chiusura e rilascio Battery
- Modulo elettronico module o brushless motor
- Pacco batteria FLEXVOLT battery
Sintomi correlati
La sega si avvia, poi si spegne bruscamente sotto carico
La lama raggiunge la velocità, entra nel legno e poi tutta la rotazione alimentata si ferma bruscamente invece di rallentare o bloccarsi nella scanalatura.
Incluso nel manuale completo
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Le pagine pubbliche mostrano solo un'anteprima. Acquista il manuale completo per scaricare passaggi di riparazione, diagrammi e procedure di verifica completi.