failure mode
FM-03: La sega si avvia, poi si ferma con il grilletto tenuto premuto
La sega si avvia, poi si ferma mentre il grilletto resta premuto, sotto carico o a vuoto.
Panoramica diagnostica
La sega si avvia, poi si ferma mentre il grilletto resta premuto, sotto carico o a vuoto.
Cause probabili
- Pack protection opened for charge or temperature
- Blade was pinched, bound, or overloaded by the cut
- Pack is loose or the contacts are intermittent under vibration
- Blocked vents or heavy loading caused thermal protection
- Internal control or motor fault
Controlli rapidi
- The saw runs steadily at no load and through a controlled supported cut.
Anteprima riparazione
- Release the trigger and wait until the blade stops completely.
- Remove the battery, free the saw from the work, and clear any pinching or blocked vents.
- Install a charged known-good pack and run the saw briefly at no load.
- - If no-load cutout repeats, keep the saw out of service - if stable, correct blade, support, and feed.
Questa è un'anteprima della guida alla risoluzione dei problemi inclusa nel manuale di riparazione completo.
Riparazioni comuni
- Motor, scatola ingranaggi o mandrino
- Interfaccia battery FLEXVOLT
- module elettronico e motor
- FLEXVOLT battery compatibile
Sintomi correlati
La sega si avvia, poi si ferma con il grilletto tenuto premuto
La sega si avvia, poi si ferma mentre il grilletto resta premuto, sotto carico o a vuoto.
Incluso nel manuale completo
- root cause analysis
- tools needed
- step-by-step repair procedure
- diagrams
- exploded views
- post-repair checks
Le pagine pubbliche mostrano solo un'anteprima. Acquista il manuale completo per scaricare passaggi di riparazione, diagrammi e procedure di verifica completi.