FM-22: Sudut Bevel Tidak Bisa Disetel, Dikunci, Ditahan, Atau Dibaca Dengan Benar

Alas tidak dapat dimiringkan melalui rentang yang dimaksud, tuas bevel tidak dapat mengunci, sudut bergeser saat memotong, atau penunjuk/kuadran tidak memberikan sudut yang dapat diulang.

• Sawdust is packed at the pivot, quadrant, pointer, or lever
• Lever is loose, stripped, cracked, or incorrectly positioned
• Shoe, pivot, quadrant, or pointer is bent or worn
• Zero calibration or angle reading is being confused with a general locking failure

1. The shoe sets within its range, locks firmly without movement, and produces a repeatable verified bevel angle.

1. Remove the battery and set the saw on a stable surface before touching the bevel lever or shoe.
2. Clean the exposed pivot, quadrant, pointer, and lever dry, then inspect for cracks, bend, missing hardware, or a lever that cannot clamp.
3. Loosen the lever counterclockwise, tilt the shoe to the desired marked angle within 0-57 degrees, and retighten the lever clockwise firmly.
4. - Check for movement by hand and confirm the angle with a gauge or a controlled scrap cut - use FM-21 only for a zero-degree calibration error.
5. If the shoe cannot move, lock, hold, or read repeatably, keep the saw out of service for authorized lever, pivot, quadrant, pointer, and shoe repair.

This is a preview of the troubleshooting guidance included in the full repair manual.

• Tuas bevel, kuadran, penunjuk, dan kalibrasi nol
• Sepatu dan pivot struktural

• Sudut Bevel Tidak Bisa Disetel, Dikunci, Ditahan, Atau Dibaca Dengan Benar

  Alas tidak dapat dimiringkan melalui rentang yang dimaksud, tuas bevel tidak dapat mengunci, sudut bergeser saat memotong, atau penunjuk/kuadran tidak memberikan sudut yang dapat diulang.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.