FM-04: Battery Tidak Akan Terpasang, Mengunci, Atau Melepaskan Dari Gergaji

Paket yang tampak kompatibel tidak akan meluncur sepenuhnya ke rel, tidak akan tetap terkunci, atau tidak akan terlepas saat tombol pelepas ditekan.

• Pack is misaligned, incompatible, swollen, or damaged
• Sawdust or a bent rail is obstructing travel
• Battery release button or latch is jammed, cracked, or not returning
• Handle rails or battery-interface housing are damaged

1. The pack slides on without force, clicks securely, cannot disengage unintentionally, and releases normally when the button is pressed.

1. Place the saw on a stable side surface, release the trigger, and do not force, hammer, or pry the pack.
2. Inspect the pack case, rails, latch, release button, and saw rails for debris, swelling, cracks, heat damage, or bent plastic.
3. Clean the rails dry, align the pack squarely, slide until it latches, or press the release fully and pull the pack straight out.
4. - Compare with a known-good compatible pack - if the tool rails, latch, release, or housing remain damaged or jammed, keep the saw out of service for authoriz

This is a preview of the troubleshooting guidance included in the full repair manual.

• Rel, kontak, kait, dan pelepas Battery

• Battery Tidak Akan Terpasang, Mengunci, Atau Melepaskan Dari Gergaji

  Paket yang tampak kompatibel tidak akan meluncur sepenuhnya ke rel, tidak akan tetap terkunci, atau tidak akan terlepas saat tombol pelepas ditekan.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.