Gergaji atau Battery Terlalu Panas atau Pemadaman Panas Berulang

Gergaji atau paket menjadi sangat panas, kehilangan output, atau berhenti selama potongan yang didukung.

• Vents are blocked by sawdust or the saw is covered
• Blade is dull or the feed load is excessive
• Battery is hot, cold, low, damaged, or unsuitable
• Cut depth, support, or material is overloading the saw
• Motor, bearing, controller, or battery fault

1. A light supported cut completes without abnormal heat or shutdown.

1. Release trigger, remove pack, and place both on a clear surface.
2. Let saw and pack cool naturally, then brush the vents and inspect for damage or odor.
3. - Fit sharp blade and good pack - correct depth and support - test lightly.
4. If abnormal heat or shutdown returns, stop use and seek qualified service.

This is a preview of the troubleshooting guidance included in the full repair manual.

• FM-14: Fm Dcs575 14

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.