Gergaji Tidak Akan Mulai atau Memberikan Respon Apa Pun

- Menekan kunci lepas dan pemicu tidak menghasilkan motor atau gerakan bilah - lampu kerja mungkin tetap mati.

• Battery pack is discharged, too hot or cold, or faulty
• Pack is not fully seated or its contacts are obstructed
• Trigger lock-off button is not fully released or is damaged
• Trigger movement is blocked or damaged
• Internal switch, controller, or motor fault

1. The saw starts normally with a latched known-good pack.

1. Release the trigger, remove the battery, and let all blade motion stop.
2. Inspect the battery rails, contacts, lock-off, and trigger for damage or loose dry debris.
3. Install a charged known-good compatible pack until it latches, then press lock-off and pull the trigger.
4. - Test at no load - if motor, blade, and worklight stay dead, keep the saw out of service.

This is a preview of the troubleshooting guidance included in the full repair manual.

• FM-01: Fm Dcs575 01

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.