FM-13: Pengaturan Kemiringan atau Akurasi Potong 90 Derajat Salah

Tuas bevel tidak terkunci, pengaturan kuadran bergerak, atau potongan tidak persegi saat penunjuk di nol.

• Bevel lever is not fully tightened
• Sawdust blocks the quadrant or shoe pivot
• Pointer or calibration stop is out of adjustment
• Shoe, quadrant, or pivot is bent from impact
• Blade or spindle runout is creating a false angle

1. The lever holds, the zero setting is square, and a scrap cut verifies the angle.

1. Remove the battery, set the bevel to zero, and place the saw on its blade side.
2. Brush the quadrant and pivot, then confirm the lever clamps firmly through the range.
3. Check blade-to-shoe squareness with a square and verify the kerf indicator on scrap.
4. If adjustment will not hold or structure is bent, stop and use qualified service.

This is a preview of the troubleshooting guidance included in the full repair manual.

• Tuas bevel dan kuadran
• Panduan kerf dan slot pagar rip
• Perakitan kedalaman, bevel, atau sepatu

• Pengaturan Kemiringan atau Akurasi Potong 90 Derajat Salah

  Tuas bevel tidak terkunci, pengaturan kuadran bergerak, atau potongan tidak persegi saat penunjuk di nol.

• root cause analysis
• tools needed
• step-by-step repair procedure
• diagrams
• exploded views
• post-repair checks

Public pages show a preview only. Purchase the full manual to download complete repair steps, diagrams, and verification procedures.